I am catalyst 3560 switch with IOS version 12.4(55). I have configured my switch to get access to CISCO Configuration Assistance tool, but it is not authenticating to my tool even i give correct usernames and passwords. Giving you the configuration below.
After i did this configuration in my switch, i have tried to open with configuration assistance tool and given username is admin and password is admin. But it is not authenticating and asking me to enter username and password with Privilage_level_15. I have tried the same in web browser also no luck and giving me same error.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...