I am wondering if this is possible, and how to execute.
We have a separate physical network for guest wireless access that we will be using a cisco 2504 controller and AP's. I wanted to manage the WLC from the corporate network, and wanted to have a management interface on our DMZ to allow 443 management from inside our corporate network.
I tried making the built in management interface on our corporate DMZ network, and another interface for the Guest Network, but I am unsuccessful:
Management port 1: 192.168.x.x
Dynamic interface port 2: 10.5.x.x
Once I enable Dynmaic AP management on the Guest network, I cant ping any devices on that network.
I also tried making a VLAN for the management network and another vlan for the Guest network and mapping them to the single built in management port, but I have been unsuccessful in that.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...