Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Out of Band remote management dial in access

I have a cisco 2821 router with a WIC-1AM card in it.  The router recognizes it ( ie it shows up as an async interface).


Could someone please point me towards a configuration guide or example that would show me how to configure this for  remote access?

The end goal of this is if the internet circuit goes down I can dial into the router to see if it is a router issue and make changes as necessary.

There will be a POTS line connected to the wic card and I have a phone number for the card.


Thank you

Lynne

1 REPLY

Re: Out of Band remote management dial in access

1279
Views
0
Helpful
1
Replies
CreatePlease to create content