Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX 501 & Branch Office

Hi,

Attached is the network diagram and Pix Configuration. We have data circuits for all our branches just installed. The problem is that the Pix just stops to ping the branch Office routers.

1. From the Pix can ping 192.168.1.2 & 1.3

2. From 192.168.1.2 & 1.3 can ping all the networks.

3. From the Pix cannot reach the branch routers.

Appreciate all your support.

Regards

Sarfaraz

2 REPLIES
Silver

Re: PIX 501 & Branch Office

Hi Sarfaraz,

Add following command to the PIX and then check and post results:

icmp permit any inside

HTH

Saju

pls rate helpful posts

Re: PIX 501 & Branch Office

What side of the branch routers can you not reach? If you source your ping on the pix, does it work? (ping outside 192.168.x.x)

Do a debug icmp trace (I think), and it will show you where you're losing your packets.

John

HTH, John *** Please rate all useful posts ***
177
Views
0
Helpful
2
Replies