I want to build an scheme for a Point of Service, I mean I have a Point of Sales (VERIFONE) it make a call to a pre configure number that i have connect to a AS5350, after I received the call I must redirect to a LAN environment where a TANDEM or STRATUSS system is going to received the packet (transaction). After this I receive in the POS a confirmation.
POS ------- ) AS53500 ------) LAN -------) Stratus or Tandem
POS-point of service or point of sale. A terminal such as those used by gasoline service stations to charge customers for merchandise and services. A POS is a PC with an internal modem and software
Tandem switching allows the route of calls to a hub location prior to the reach of the final destination, where you can also modify the dial plan and destination pattern.
NTP uses the concept of a "stratum" to describe how many NTP "hops" away a machine is from an authoritative time source. A "stratum 1" time server typically has an authoritative time source (such as a radio or atomic clock, or a GPS time source) directly attached, a "stratum 2" time server receives its time via NTP from a "stratum 1" time server, and so on.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...