Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PPP connection timeouts

Hi,

I am working on a project in which I connect a SDC modem with my router 3725 on Smart serial port.

The scenario is, A node dial to router, when user dial to Access Server (ROUTER 3725), After the connection is establish and user get an IP address from the Router, when user ping to router reply will comes fine but after 10 to 15 replies, continuously timeout comes, while connection remain established. There is no any dynamic routing protocol use and no access-list is applied on the interface.

Please Help me.

3 REPLIES

Re: PPP connection timeouts

Hi

Can you post the config here and also the log details of the packet drops which you are getting ??

Are you trying to access any application via this connectivity ?

if yes are you trying to access any servers or anything else and getting the drops ??

coz sometime u may get into loading issues also with this kinda of connectivities..

also revert back the kinda external connectivity to the modem is it a normal pstn line terminated in that modem or some other kinda connectivity ?

regds

New Member

Re: PPP connection timeouts

Hi

yes i am trying to access an applecation running on a server but now i simply ping the server and its reply timeouts. the configuration is under blow..

The problem is when the connection is esteablish to the server it pings, but after 10 to 15 pings, timeouts comes, while the connection remain active.

I am using a PSTN network of the connectivity..

Regards,

Re: PPP connection timeouts

Hi

From my personal exp with the dial up connections though u get times out u will be able to workout with the applications.

Can you try to stop the ping and try browsing or working with the application and check whether you are really able to work/connect to the server..

Also once you get connected can you issue show users and show connection.using these command you can actually verify the state of the connections on ur router side..

this link will also help u out to get the config verified..

http://www.cisco.com/en/US/products/hw/routers/ps221/products_configuration_guide_chapter09186a008007cd2e.html

regds

156
Views
0
Helpful
3
Replies