Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

pppoe question

Hello,

We have a 7206 terminating pppoe sessions. We have noticed

that sometimes the 7206 Rxs a PADT for a pppoe session (while the 7206 has already Txed the first LCP conf-req for this session which means that 7206 is in the ppp lcp stage) and responds with a Term-Request.

Afterwards, the 7206 tears down its pppoe session without sending any PADT.

Is this normal? (the fact that 7206 does not Tx any PADT after the Term-request plus the fact that 7206 Txs a LCP Term-Request as a response to the Rxed PADT)

*The discovery process (pppoed) always completes normal

Thank you all!!!

1 REPLY
Bronze

Re: pppoe question

After the time of the idle or session timer has expired, the LAC should send out a PADT towards the PPPoE client and the LNSs to terminate the session. Refer the follwoing URL for more information

http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/prod_release_note09186a00800877cc.html

122
Views
0
Helpful
1
Replies
CreatePlease to create content