Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PPPoE session RADIUS VRF

Hi,

I have to deploy the following scenario:

PPPoE Sessions terminated on a 802.1q GEth Subinterface on a 7206 Router.

It should be possible to put some customers (based on domain name) into a VRF (vrf-lite) instance.

The vrf-id should provided by a Radius Server.

Has anyone a similar config to give me a feedback or a useful link) ?

Thanks and regards,

Thomas

  • Remote Access
2 REPLIES
Silver

Re: PPPoE session RADIUS VRF

You can assign VRF membership to virtual-access interfaces using

a) Cisco-avpair = "lcp:interface-config#1=ip vrf forwarding "

Cisco-avpair = "lcp:interface-config#2=ip unnumbered loopback"

or

b) Cisco-avpair = "ip:vrf-id="

Cisco-avpair = "ip:ip-unnumbered="

Option a forces full Vaccess interfaces, option b works with virtual-access subinterfaces, but is not supported in all releases..

http://www.cisco.com/en/US/docs/ios/mpls/configuration/guide/mp_vpn_half_dup_vrf.html#wp1099246

New Member

Re: PPPoE session RADIUS VRF

Hi,

I have the same problem on Cisco 10008.. it seems that it can't go without RADIUS server.

Domagoj

753
Views
0
Helpful
2
Replies
This widget could not be displayed.