Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PRI remote acces with B cahannel issue

hello,

On cisco 3640 RAS I have a channel issue, users are deconneted intempesively.

With the modem debug I have this message:

Jan 7 09:25:15: CSM: MODEM_REPORT rcvd DEV_IDLE for call_id 0x14D, modem

not found due to wrong b channel number or b channel is deallocated

Jan 7 09:25:15: TTY44: DSR was dropped

Jan 7 09:25:15: tty44: Modem: READY->HANGUP

Jan 7 09:25:15: TTY44: dropping DTR, hanging up

Jan 7 09:25:15: Modem 1/11 CSM: (CSM_PROC_IDLE)<--ASYNC_DTR_DOWN

Jan 7 09:25:15: tty44: Modem: HANGUP->IDLE

Jan 7 09:25:16: TTY44: cleanup pending. Delaying DTR

Jan 7 09:25:16: TTY44: cleanup pending. Delaying DTR

Jan 7 09:25:16: Modem 1/11 Mica: PPP escape_map: Tx map = FFFFFFFF, Rx map

= 0

Jan 7 09:25:16: %LINK-5-CHANGED: Interface Async44, changed state to reset

Is it a configure problème, a hardware or a telecom compagny issue.

thanks for your helps.

Bests regards

Omar

2 REPLIES
Silver

Re: PRI remote acces with B cahannel issue

better authenticate the dial-up clients before telnetting the device

New Member

Re: PRI remote acces with B cahannel issue

thanks for your indications,

I have tests to increase the timer (idle-timeout) and it is going better.

bests regards

Omar ATTOUMANI

155
Views
0
Helpful
2
Replies