Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problem in calling BRI from PRI

Hi,

I am having problem in calling BRI from PRI. I am getting below message while debugging. Also note that calling from BRI to PRI is successful.

Mar 2 23:38:22: ISDN BR0/0 Q931: RX <- SETUP pd = 8 callref = 0x04

Sending Complete

Bearer Capability i = 0x8890

Standard = CCITT

Transer Capability = Unrestricted Digital

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0x89

Progress Ind i = 0x8281 - Call not end-to-end ISDN, may have in-band info

Calling Party Number i = 0x2183, '1726601501'

Plan:ISDN, Type:National

*Mar 2 23:38:22: ISDN BR0/0:1: Incoming call rejected, unbindable

*Mar 2 23:38:22: ISDN BR0/0 **ERROR**: host_incoming_call: DIALER ERROR 0x1: b channel 0, call id 0x15E

*Mar 2 23:38:22: ISDN BR0/0 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x84

Cause i = 0x8095 - Call rejected

Pls help me.

Anis

9229109694

7 REPLIES
Hall of Fame Super Gold

Re: Problem in calling BRI from PRI

Please send BRI router config and what router / card it is.

New Member

Re: Problem in calling BRI from PRI

Pls find the config attachment of BRI end.

Card is Cisco WIC 1B-S/T

Silver

Re: Problem in calling BRI from PRI

Hi ,

Pease configure username and password on both routers ...in privileged mode.

cheers :)

satish

New Member

Re: Problem in calling BRI from PRI

Dear Satish,

Can u pls give me an example for this config.

As Enable Secret is already configured on both the Routers.

Anis

Hall of Fame Super Gold

Re: Problem in calling BRI from PRI

Yes you have to configure "ppp chap username" under dialer interface.

Silver

Re: Problem in calling BRI from PRI

PPP Multilink is not been enabled...

If it is enable than use rotary group command.

" EITHER " command.

Regards,

Dharmesh Purohit

New Member

Re: Problem in calling BRI from PRI

Dear Dharmesh,

Can u pls explain where to enable PPP Multilink.

Dear p.bevilacqua ,

I did what u told (configure "ppp chap username" under dialer interface), but the problem is same.

Anis

178
Views
0
Helpful
7
Replies
CreatePlease to create content