Yesterday during the annual Disaster Recovery Plan scenario of my company, I noticed that 4 of 30 branches did not dial in to DRP router and I do not know why. The case is quite simple. The branch router when loose his primary leased line connection try to connect through the backup ISDN BRI line dialing the first number and if this number is unavailable try to dial out the second one in DRP site. Unfortunately this did not work out/ From some debug messages in branch router I found out that router even do not try to dial out the second number.
The case is when the BRI interface is configured only with one number either the dialer string of HQ or the dialer string of DRS the call being established. But when the BRI interface is configured with both dialer strings the router tries to dial out only the first number and seems to ignore completely the second one. For the DRS scenario I had disabled the first number by shutting down the relevant HQ PRI, so only the DRS PRI was available.
Any idea for this behavior?
I have also the same router model with the same IOS version and the same configuration to another branch, which operate normally. I mean that when the primary leased line is down , then tries to dial out the first dialer string. If this number is out of order then tries to dial out the second one which belong to DRS and connect finally to DRS router.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...