Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Problem With PRI

Dear All,

I have a 2811 router and I wud like to go for an PRI (ISDN) connectivity on that, however I want that PRI shud be terminated a Serial WIC-1T card using the V.35 interface..

Plz also tell me whether cisco 2811 support PRI or not.. ???

on Which card I or Module it will fixed up..

1 REPLY
Bronze

Re: Problem With PRI

Hi Farhan

PRI is supported on the 2811

You can go for any one of the below modules

NM-1CE1T1-PRI 1-port Channelized E1/T1/ISDN-PRI network module

NM-2CE1T1-PRI 2-port Channelized E1/T1/ISDN-PRI network module

If you insist on a serial termination, you will have to use a TA which in most cases is recommended by your telecom service provider.

For serial connectivity you can use any one of the following:

Serial Connectivity Network Modules

NM-1HSSI 1-port High-Speed Serial Interface (HSSI) network module

NM-4A/S 4-port asynchronous/synchronous serial network module

NM-8A/S 8-port asynchronous/synchronous serial network module

NM-16A/S 16-port asynchronous/synchronous serial network nodule

NM-16A 16-port asynchronous serial network module

NM-32A 32-port asynchronous serial network module

The complete list is available on

http://www.cisco.com/en/US/products/ps5854/products_relevant_interfaces_and_modules.html

Now all you need to decide is how many ports do you need :)

HTH

Please rate posts that help.

Regards

Arvind

133
Views
4
Helpful
1
Replies
CreatePlease to create content