Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Problems with 2851 and PVDM2

Hi, I have a 2851 with PVDM2-36DM but I wasn't able to work with them. It takes a long time the handshake, then a low speed connection and finally a disconection.

I want to try with a modemcap for this kind of modem, or any other suggestion? My modem firmware is V3_09.

TIA

3 REPLIES
Hall of Fame Super Gold

Re: Problems with 2851 and PVDM2

Can you post "show controllers E1" ?

Community Member

Re: Problems with 2851 and PVDM2

BOT-RAS-PRUEBA#sh controllers e1 1/0

E1 1/0 is up.

Applique type is Channelized E1 - balanced

No alarms detected.

alarm-trigger is not set

Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.

Module type is Channelized E1/T1 PRI

Version info Firmware: 0000001D, FPGA: C

Hardware revision is 0.0 , Software revision is 29

Protocol revision is 1

number of CLI resets is 1

Last clearing of alarm counters 00:05:43

receive remote alarm : 0,

transmit remote alarm : 0,

receive AIS alarm : 0,

transmit AIS alarm : 0,

loss of frame : 0,

loss of signal : 0,

Loopback test : 0,

transmit AIS in TS 16 : 0,

receive LOMF alarm : 0,

transmit LOMF alarm : 0,

MIB data updated every 10 seconds.

Data in current interval (343 seconds elapsed):

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

BOT-RAS-PRUEBA#

Hall of Fame Super Gold

Re: Problems with 2851 and PVDM2

Can you try FW 3.11 ?

184
Views
0
Helpful
3
Replies
CreatePlease to create content