Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problems with L2tp/IPSEC Remote access VPN Gateway

Hie guys!!! Please can you help me i am having problem connecting to my private lan using a windows client. I am simulating a vpn connection from inside my private lan.PPTP is working okay L2tp comes up with error 'remote machine did not respond' I have attached my router configuration and the debug output. My client config should be fine..What is wrong with my router config?????

2 REPLIES
New Member

Re: Problems with L2tp/IPSEC Remote access VPN Gateway

Hi,

take a look here:

http://www.cisco.com/en/US/tech/tk827/tk369/technologies_configuration_example09186a00801e51e2.shtml

vpdn enable

vpdn-group 1

accept-dialin

protocol pptp

virtual-template 1

ip local pool test 192.168.1.1 192.168.1.250

interface virtual-template 1

encapsulation ppp

peer default ip address pool test

ip unnumbered FastEthernet0/0

no keepalive

ppp encrypt mppe auto

ppp authentication pap chap ms-chap

That's all.

Regards, Celio

New Member

Re: Problems with L2tp/IPSEC Remote access VPN Gateway

Thanks Celiocarreto,,, I wanted to connect using l2tp/ipsec. With pptp my config work fine but then i just discovered that its NAT which is causing problems (the addresses being changed when i try to go out and then back inside) since i am emualting this inside my private lan.. I tested it from ouside and works fine....Topic Closed,,, Many thanks

194
Views
0
Helpful
2
Replies