12-19-2005 02:55 AM
I've just put NM-4B-S/T in 2811 route and started router but router cannot see this modul. All LEDs on NM-4B-S/T are green and router can see the other interfaces. Could you give me some advice?
12-19-2005 03:29 AM
Hello,
which IOS version are you running ?
The module is supported starting with 12.2(8)T, 12.3(8)T should also recognize it. Can you try and load any of these ?
Regards,
GP
12-19-2005 04:18 AM
the IOS ver is c2800nm-advsecurityk9-mz.123-11.T5.bin
12-19-2005 07:13 AM
I have IOS c2800nm-advsecurityk9-mz.123-11.T5.bin on the router how can I get above ver to test it?
Hardware ver of this card is 0.
12-19-2005 07:45 AM
Hello,
is this a new module ? The IOS version is sufficient. Do you have another router where you can test this in ? The module could simply be broken...
Regards,
GP
12-19-2005 09:00 AM
yes it is new as a router. I tested this module in cisco 2611 router and it recognized it. Also I tried with IOS c2800nm-advipservicesk9-mz.124-3a.bin without success. Is it maybe problem with hardware version and 2800 router series.
12-20-2005 02:44 AM
Hello,
can you try 12.3(8)T ? I have seen cases where you need the exact IOS version that is required. Higher versions are not necessarily always backwards compatible...
Regards,
GP
12-20-2005 04:15 AM
how and where can get it?
12-21-2005 12:11 AM
Hi
You can download the reqd IOS code from here...
http://www.cisco.com/kobayashi/sw-center/sw-ios.shtml
But do note that you need to have the login with necessary privileges to do so..
regds
12-23-2005 02:55 AM
Hi,
I tried with 12.3(8)T but the router still cannot see it. I put this modul in 2611XM and this router see it without problem. Also I put another NM modul in 2811 NM-8B-S/T=, router see it without problem.
I think the router (2811) is OK and also probably NM-4B-S/T but there is a conflit between them.
I'll try to replace this module.
12-23-2005 03:06 AM
Hi
As per the datasheet avl Cisco 2811 does support NM-4B-S/T card.
http://cisco.com/en/US/products/ps5854/products_data_sheet0900aecd8016fa68.html
Can you post out the show version and show controllers o/p here ??
regds
12-23-2005 04:35 AM
12-23-2005 05:48 AM
Hi
Currently you are running with 12.3(11).T5.bin can you try to run with the ios code as prescribed by GP in his earlier post ?
have u uploaded the other version 12.3(8)T onto ur router and tried running with that ?
regds
12-23-2005 06:19 AM
As I said Ive already tested with 12.3(8)T without success.
12-23-2005 06:57 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide