whenever I try to configure a service-policy under pvc mode as recommended on the Cisco docs the command is accepted but it just doesn´t show up in the final config, also using the command you mentioned I can clearly see that the policy is not operational:
You cant apply a QoS policy to an ATM PVC without traffic shaping configured. Best (and most often configured) ATM traffic shaping is vbr-nrt. Basically you plug in your upload bandwidth and it'll traffic-shape you to that rate. More importantly, it helps the QoS schedule allocate bandwidth for the various classes.
Do the following:
vbr-nrt 768 768
Once you exit out of this, the command should have stuck, and you'll be able to issue a 'show policy-map interface atm0/0/0.1'.
If you're upload speed isn't 768k, change the vbr-nrt statement to whatever the speed is, in kbps.
You may also notice I put in a tx-ring-limit command. This is needed to create backpressure from the module to the router, telling it to use the QoS classes you have configured.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...