I need to establish RAS access to my network via an ISDN PRI line. Most users will be single POTS line users but I'll also need to allow bundled POTS line users via Microsoft multilink PPP. I'm planning to order a Cisco 2811 to handle this using a NM-1CE1T1-PRI module for the PRI and a PVDM2-24DM for the calls. Will this setup handle my requirments?
Cisco Digital Modem PVDMs are designed to be used in conjunction with the single or dual ISDN PRI network module NM-1CE1T1-PRI (1-Port Channelized E1/T1/ISDN-PRI Network Module). so Its sufficent for your needs.
Thanks for your response. I have since determined that this was exactly what I needed and have oredered and rece'd all but the PVDMs. Apparently, finding light in a black hole might be easier than obtaining one of this modules. Thanks again.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...