Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Re: New Installation of AS5350XM

Hi,

I am installing a new AS5350XM which I am replacing with an existing AS5350. I need some help in the following task :-

1) I want to configure the clock from my E1 feature card. The command from the doc says

conf t

dial-tdm-clock priority {slot/ds1 port}.

But I am unable to enter the 'dial-tdm-clock' command on the CLI. It seems that the command does not exist. I am using the IOS version c5350-is-mz.124-10c.bin.

2) Do I need to configure the SPE setting for users to dial in via the modem or can I just ignore this piece of configuration ?

Pls advice,

Cheers,

- sn -

1 REPLY
Silver

Re: Re: New Installation of AS5350XM

1.To troubleshoot your E1 or T1 controllers, first check that the configuration is correct.

2.Another common reason for failure is the dial-tdm-clock priority setting. The default setting is a free-running clock that causes clock slip problems if not set properly

3. Make sure you are running minimum 11.3(2)AA .

118
Views
0
Helpful
1
Replies
CreatePlease to create content