cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
277
Views
0
Helpful
1
Replies

Redundant VPN support b/w Pix and Routers

ybtheneonet
Level 1
Level 1

I've tried to get a redundant VPN setup going between my PIX at one end and two routers at the remote office end. But it just doesn't work? ISAKMP negotiations happen, but phase two doesnt start. I turned on the debug's but couldnt make sense of it. I'll post the debug later tonight. And no, i was'nt using NAT anywhere in between.

I replaced the pix with a 1800 ISR and it works well!.. Does anyone know of any compatibility issues between a PIX and a Router regarding VPN??

Another question i have is :

In the PIX when i enter the

#crypto isakmp key cisco address <IP>, it gets converted into a tunnel-group command and gets stored in the config? Does anyone know why this happens? is the crypto isakmp key command deprecated?

1 Reply 1

ybtheneonet
Level 1
Level 1

No takers?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: