I've tried to get a redundant VPN setup going between my PIX at one end and two routers at the remote office end. But it just doesn't work? ISAKMP negotiations happen, but phase two doesnt start. I turned on the debug's but couldnt make sense of it. I'll post the debug later tonight. And no, i was'nt using NAT anywhere in between.
I replaced the pix with a 1800 ISR and it works well!.. Does anyone know of any compatibility issues between a PIX and a Router regarding VPN??
Another question i have is :
In the PIX when i enter the
#crypto isakmp key cisco address <IP>, it gets converted into a tunnel-group command and gets stored in the config? Does anyone know why this happens? is the crypto isakmp key command deprecated?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...