Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Remote access using Robotics modem

Hi,looking for advice to connect to various 1700,2500,&3600 series routers via dialup. I get window, but no prompt. I've done following:

. changed cable (router to modem)

. reset options on modem

. rebooted router and modem

. cleared line aux 0

Any ideas, would appreciate the help.

2 REPLIES

Re: Remote access using Robotics modem

Hi,

Please post the following;

1. Router AUX config

2. Hyperterminal Settings

Check this link http://www.cisco.com/warp/public/471/mod-aux-exec.html

Regards,

Dandy

New Member

Re: Remote access using Robotics modem

Here is config:

line aux 0

password xxx

autobaud

script startup aux

login

modem InOut

transport input all

flowcontrol hardware

CLI output on AUX 0:

Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns

1 AUX 2400/2400 F inout - - - 0 0 0/0

Line 1, Location: "", Type: ""

Length: 24 lines, Width: 80 columns

Baud rate (TX/RX) is 2400/2400, no parity, 2 stopbits, 8 databits

Status: No Exit Banner

Capabilities: Autobaud Full Range, Hardware Flowcontrol In,

Hardware Flowcontrol Out, Modem Callout, Modem RI is CD

Modem state: Idle

Modem hardware state: CTS* noDSR DTR RTS

Special Chars: Escape Hold Stop Start Disconnect Activation

^^x none - - none

Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch

00:10:00 never none not set

Idle Session Disconnect Warning

never

Hyperterm is set at 8,N,1 tried various speeds from 2400 - 38400

210
Views
0
Helpful
2
Replies