Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Remote Access VPN Problem

hello folks,

I am emulating a remote access VPN setup in my Lab setup. I get connected alright but when I am connected, the remote access client is not able to ping any of the local LAN devices and as such can not access local resource.

Below is the LAN configurations acquired by the VPN client when connected. From what I see, it picks an IP from the local pool for its gateway instead of the default gateway of the local LAN.

Ethernet adapter Local Area Connection 3:

Connection-specific DNS Suffix . :

Description . . . . . . . . . . . : Cisco Systems VPN Adapter

Physical Address. . . . . . : 00-05-9A-3C-78-00

Dhcp Enabled. . . . . . . . . . . : No

IP Address. . . . . . . . . :

Subnet Mask . . . . . . . :

Default Gateway . . . . . .:

DNS Servers . . . . . . . :

Any assistance please.

Attached is my configuration of the router.


Re: Remote Access VPN Problem


to solve this problem

u have to configure what is called split tunneling

inthe case case u gonna creat ACL with this ACL u gonna decide which traffic that should be go through the vpn tunnel and which should not

for example if have network behind the router u need to access it by vpn and this network is

do the following

access-list 100 permit ip any

then under the vpn client group configuration mode( where u applied th pool)

add the following command

acl 100


in this case the client will use the vpn tunnel only for traffic going to 10.1.0/24 network

ant thing else will use ur normal lan config

good luck

please if helpful Rate