08-03-2010 12:01 PM
hello I small problems I Cisco router 800 serials now I remote wants work by means of SSH and telnet now are my question how can you this do?
who can help me
Solved! Go to Solution.
08-05-2010 06:09 AM
I didn't see your SSH configuration on the ZBFW.
Please configure the following
class-map type inspect match-all ssh-class match protocol ssh
policy-map type inspect ccp-permit
class type inspect telnet-class
inspect
08-05-2010 06:51 AM
on this small file is correct has it done that a little?
kind regards
08-05-2010 07:24 AM
That configuration looks OK. It should work now.
08-05-2010 07:53 AM
no it not yet works because if I take another isp I do telnet SSH connection then get I time out?
08-05-2010 07:55 AM
not sure what you mean by another ISP?
Can you SSH to it locally?
08-05-2010 08:00 AM
I my postages have let check on gateway 22 (SSH) 23 (telnet) and that am closed how you can open that
08-05-2010 08:06 AM
I don't see 2 ISP on your configuration. Your configuration only says gig0 as the external interface.
08-05-2010 08:22 AM
08-05-2010 08:44 AM
I don't understand what you mean.
08-05-2010 09:00 AM
the postage 22 is closed same the postage 23 is closed how is possible you that open putting?
08-05-2010 09:40 AM
the postage 23 is closed on the router can you the postage open?
08-06-2010 03:16 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
