08-03-2010 12:01 PM
hello I small problems I Cisco router 800 serials now I remote wants work by means of SSH and telnet now are my question how can you this do?
who can help me
Solved! Go to Solution.
08-05-2010 06:09 AM
I didn't see your SSH configuration on the ZBFW.
Please configure the following
class-map type inspect match-all ssh-class
match protocol ssh
policy-map type inspect ccp-permit
class type inspect telnet-class
inspect
08-05-2010 06:51 AM
08-05-2010 07:24 AM
That configuration looks OK. It should work now.
08-05-2010 07:53 AM
no it not yet works because if I take another isp I do telnet SSH connection then get I time out?
kind regards
08-05-2010 07:55 AM
not sure what you mean by another ISP?
Can you SSH to it locally?
08-05-2010 08:00 AM
I my postages have let check on gateway 22 (SSH) 23 (telnet) and that am closed how you can open that
08-05-2010 08:06 AM
I don't see 2 ISP on your configuration. Your configuration only says gig0 as the external interface.
08-05-2010 08:22 AM
I my postages have let check on gateway 22 (SSH) 23 (telnet) and that am closed how you can open that
08-05-2010 08:44 AM
I don't understand what you mean.
08-05-2010 09:00 AM
the postage 22 is closed same the postage 23 is closed how is possible you that open putting?
kind regards
08-05-2010 09:40 AM
the postage 23 is closed on the router can you the postage open?
kind regards
08-06-2010 03:16 AM
the postage 23 is closed on the router can you the postage open?
kind regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: