Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Restrict User Access

I have successfully setup remote access where my remote users can connect and authenticate against Active Directory. I have a single pool of IP addresses that the ASA5510 hands out to the remote users. Everything works great. I now have a request from a vendor that needs remote access for support issues. I need to control this access to only allow access to a single IP address within the internal network. I don't see how to control this. Do I need to create a dynamic acl and apply it to the vendors username or is there a more simple process?

Thanks in advance for any help,

Ken

1 ACCEPTED SOLUTION

Accepted Solutions
Green
2 REPLIES
Green
New Member

Re: Restrict User Access

Thank you. That is what I needed. In all my searching I could not find a document that provided this information

121
Views
0
Helpful
2
Replies