Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Router 2811 with 12 port PVDMII digital Modems

Our customer have systems all over the world ( arround 800 locations). In these locations , there are systems that should be remotly supported. We have two kinds of systems on the remote locations

1- PC's connected to analog Modems - Connection between the center and the remote location will be PPP, in this case i would like to use the DialOut/EZ to install a virtual modem on the supporter workstation , the supporter then can user this modem to dialout to the remote location.

2- Mashines ( Industry ) that hat an integrated analog modems. The supporter use the redirected COM Port to connect to the mashine character based using AT commmands.

On the cenral side we are using a Cisco Router 2811 with 12 port PVDMII digital modem PVDM.

Can you or somebody inform if this scenario is possible with DialOut/EZ.

3 REPLIES
Hall of Fame Super Gold

Re: Router 2811 with 12 port PVDMII digital Modems

Hello,

As as far I know, any cisco router with async interfaces or embedded modems can support virtual COM ports as you indicated.

The only reason I personally don't like very much these digital modems is that the PVDM2-DMxx still requires an NM-xCE1T1-PRI instead of the much more modern and compact VWIC2-xMFT-T1/E1, but beside that, I think it should work for you.

Hope this helps, please rate post if it does!

New Member

Re: Router 2811 with 12 port PVDMII digital Modems

Hi,

I read your comment that the PVDM2-DMxx only works with NM-xCE1T1-PRI and not VWICS, I could not find this caveat on CCO do you have any further info or a link ? Thanks

Hall of Fame Super Gold

Re: Router 2811 with 12 port PVDMII digital Modems

In the data sheet at:

http://cisco.com/en/US/products/ps5855/products_data_sheet0900aecd8050918e.html

We read:

ISDN PRI Requirements

The Cisco Digital Modem PVDM Modules operate in conjunction with the following Cisco Network Modules:

* NM-1CE1T1-PRI (1-Port Channelized E1/T1/ISDN-PRI Network Module)

* NM-2CE1T1-PRI (2-Port Channelized E1/T1/ISDN-PRI Network Module)

I would be happy to learn that it works with the VWICs also.

Hope this helps, please rate post if it does!

430
Views
0
Helpful
3
Replies
CreatePlease to create content