I am working with a client who has the below setup, I know it is a little confusing.
Remote ASA -------- ASA at Home Office --------- 4506 --------- 2811 Router P2P ----------- 2811 Router P2P --------- 2960 ------- Server
So the remote ASA connects to the network at the Home Office using a L2L tunnel. All internal networks route fine that terminate at the 4506. They have a second remote site that is connected via 2 2800's as above with a leased line Metro. The clients on teh back side of that point to point need to be able to access resources behind the remote ASA. We can get pinging to work from the inside interface on the remote ASA to the server on the back side of the point to point. The issue arises that any client on the back-end of the remote ASA cannot ping or access anything on the back-end of the point to point. When we do a traceroute from the back of the remote asa the traffic all goes out the outside interface not the inside. Attached is the config from the devices, named as above (of course with IPs changed).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...