RVS4000 to WRVS4400N VPN Can't see other computers
I have a VPN tunnel up between these two routers and can't see any of the other computors accross the tunnel. I have local secure group ip set at 192.168.1.0 (rvs) and remote secure group at ip 192.168.2.0 (wrvs), subnet is 255.255.555.0. With this I also have a 100% packet loss when I ping from the router diagnostics of the rvs4000 to the wrvs4400n. I can ping all ip addresses from the command line of the computers on both sides of the tunnel. I can also ping all ip addresses from inside the diagnostics on the wrvs4400N with no problem. I downloaded the VPN setup wizard v1.2 for the rvs4000 series routers and cannot remotely or locally access the rvs4000 through this utility. I can access both router utilities locally or through
IE9 & the tunnel I created without using the utility. Netbios was checked and saved on both routers after the tunnel was created. I did a firmware upgrade on both routers rvs4000 v18.104.22.168, wrvs4400n v1.1.13. Remote access is enabled on both routers. Any help would be appreciated.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.