Our company has a lot of remote locations on which each one has it's Internet connections/address all these remote locations are connected with each other by using EZVPN.
Now split-tunnel is applied for allowing the use their own internet for public internet access, but they are requesting for them to go to the internet using the public ip address of the Central site cause some application are restricted to the public internet ip address only. These applications are not allowing to have more than one public IP from one customer. Question is how can this be configured? Same as strongVPN or others?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...