08-25-2010 01:16 AM
hello I have a question know there sometimes someone how your SSH and telnet configure router to remote ?
all tips are welcome
08-25-2010 04:19 AM
Do you mean that you are trying to SSH/telnet to the router remotely?
If that is the case, by default SSH/telnet should be enabled unless you disable it.
Check the configuration under "line vty 0 4", you should have a line that says "transport input all" which allow both SSH and telnet.
For SSH, you would need to generate RSA keypair before you can SSH to it.
For telnet, you can just telnet to it directly.
Another configuration that you might want to check is if there is any ACL applied to the interface, or line vty, and/or if there is any Zone base FW configuration.
Hope that helps.
08-25-2010 05:06 AM
yes that wants try on the line vty 0 4 transport input telnet SSH
the RSA key are generate on 1024
with telnet am not possible I remotly
I hope that someone can help me please
i
08-25-2010 05:15 AM
You have asked this same question already, but you have failed to explain what do you want to do actually.
You also have receivied a very valuable answers, again you have failed consider or understand.
Please do not open thread doplicates, and explain what you want to do in plain english.
08-28-2010 06:02 AM
I none English but Dutch for becomes the text translates
who can help me for configuring remote telnet and SSH
all tips are most welcome
08-28-2010 01:14 PM
Post your configuration here.
I suspect you are using "any any" in NAT ACL - wrong.
08-29-2010 12:04 AM
08-29-2010 10:27 AM
Configure:
interface GigabitEthernet0
no ip virtual-reassembly
no zone-member security out-zone
!
interface Vlan1
no ip flow ingress
no ip virtual-reassembly
no zone-member security in-zone
no ip tcp adjust-mss 1452
08-29-2010 10:58 AM
08-30-2010 04:27 AM
On interface GigabitEthernet0, do you receive a public or privateIP address ?
08-30-2010 06:27 AM
interface GigabitEthernet0, receive a public
08-30-2010 11:08 AM
Can you ping it from outside?
What happens when you try telnet or SSH to it ?
08-30-2010 11:19 AM
I can ping from outside do public address
I want telnet and SSH on do Cisco router for remote in at lay
08-30-2010 01:48 PM
What happens when you do SSH or telnet to router ?
08-30-2010 01:55 PM
I get time out
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: