I am becoming increasingly frustrated with an issue that I've seen span MANY different devices (both routers and switches, with varying IOSes installed).
The problem I am seeing is when I am scrolling through the logs on a router or switch (by holding the spacebar), my session will disconnect. This happens using SSH in both PuTTY and SecureCRT.
I have seen this same issue occur when performing a show tech, as well as when holding spacebar while scrolling through a show int status on some of our Nexus switches with many, many ports configured.
I have checked the available resources after signing back in, and each time available resources have been sufficient. Has anyone else experienced this issue or perhaps know of a cause/resolution?
Hello Jason! Sorry to hear about the problem. This sort of issue needs a TAC case, because there is clearly a software bug. What platform and software version are you using?
CSCsd98525 describes a similar issue, limited only to IOS. CSCsz83570 also describes a similar issue.
A workaround is to force the use of SSHv1 until you apply the software fix.
Also, at least for CSCsz83570, setting "term len 0" tends to prevent the disconnect, as does switching to 3DES instead of AES. This bug is triggered by TCP congestion and those two workarounds avod the issue. Swicthing to SSHv1 does as well.
I've had the same experience with multiple types of hardware and software versions for years. It seems to be related to the rate of info flowing to the console. A show tech w/term len 0 usually will trigger it.
Not sure if it can be fixed, I can of learned to pace myself when on a remote session...
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...