Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Stop Async modem auto answering.

Hi,

This has me racking my brains for what should be (and no doubt is) a simple request.

I have a wic-1am-v2 installed in a 2801 (adv ip 124(24.T1)) , i am using this for a outgoing dialer.I wish to stop this modem auto answering.

NAME: "WIC/VIC/HWIC 1", DESCR: "WAN Interface Card - One Port Analog Modem(Version 2)"

PID: WIC-1AM-V2 , VID: V01 ,

interface Async0/1/0

no ip address

encapsulation ppp

dialer in-band

dialer pool-member 10

async mode interactive

end

Does anyone have any ideas short of sending a direct AT command to the modem card?

For ref I know that for a bri i can use the following with great success

"isdn caller 12345678912"

" isdn reject data" etc etc

Thanks in advance

Graham

2 REPLIES
Hall of Fame Super Gold

Re: Stop Async modem auto answering.

You can issue commands with regular reverse telnet.

Silver

Re: Stop Async modem auto answering.

If you can do a reverse telnet into the modem from the router, as Paolo suggests, I think you could just enter the following command to disable auto-answer and save the setting to nvram.

ats0=0&w

You can check the modem settings with the following command:

at&v

HTH

413
Views
5
Helpful
2
Replies
CreatePlease login to create content