Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

ubr7114 In bridge mode

I want to configure an ubr7114 in bridge mode and I need to know if in this mode the ubr7114 supports the same amount of cablemodems per upstream that it is supported in routing mode and if exists any adicional limitation that I should consider.

Thanks, Guillermo.

1 REPLY
Silver

Re: ubr7114 In bridge mode

Unlike the uBR7200, the uBR7100 can be used as a bridge. The bridging configuration consists of disabling IP routing, putting all of the interfaces in one bridge group, and configuring the cable interface. In this configuration, routing functions are done on the uBR7100's gateway/router.

http://www.cisco.com/en/US/products/hw/cable/ps2211/products_configuration_example09186a00801575cc.shtml

231
Views
0
Helpful
1
Replies
CreatePlease to create content