Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unable to establish ISDN Conection

When I given Command

Sh isdn status

allway fist layer deactivate and

second layer not activated.

I and many time tested line parameter

by isdn provider they tell me line parameter are ok. but when we connect line to nt1 and router they tell me isolation more then 1k arrive in line parameter.

whats probles tell me are who to solve.

3 REPLIES
Hall of Fame Super Gold

Re: Unable to establish ISDN Conection

hi,

do "debug bri", "debug isdn q921" debug isdn q931" "term mon".

then isdn test call int x/y 1234

this will tell you what's going on.

Hall of Fame Super Silver

Re: Unable to establish ISDN Conection

Paolo

Your suggestion of debugs is a good combination of debugs to investigate most ISDN problems. But if:

Sh isdn status allway fist layer deactivate and

second layer not activated

then I am afraid that the results of the testing is going to be very predictable. What can 921 or 931 show if layer 1 and 2 are not active?

My suggestion is to look for a layer 1 issue:

- is the cable plugged into the correct port on the router?

- is that same cable plugged into the provider ISDN terminated connection?

- is that any possibility of a patch connection somewhere between the router and the NT1 that is not correctly connected?

- is the ISDN card the correct one to connect to an NT1?

HTH

Rick

Hall of Fame Super Gold

Re: Unable to establish ISDN Conection

Hi Rick, with all debugs enable it's easy to see the proper sequence of events, and one doesn't have to ask repeatedly :)

132
Views
0
Helpful
3
Replies
CreatePlease login to create content