Urgent-NAT-Dial

[giaaaj]

Hi,

I have a router with digital modems in the center and have 10 Remote-sites that use the same subnet

Remote-site 1 : Subnet 192.168.1.0/24

Remote-site 2 : Subnet 192.168.1.0/24

Remote-site 3 : Subnet 192.168.1.0/24

and so on

Each subnet is equiped with a device that have an analog modem on the wan-side and an ethernet interface connected to the subnet. The wan interface on this device have a fixed ip address which also the same in all remote-sites

Ist there any way to connect to these subnets at the same time from the same router using a dialing method?.

Thx

Ali

[purohit_810]

You can follow following configuration with ISDN dial-up connectivity.

http://www.cisco.com/en/US/products/sw/secursw/ps4911/products_user_guide_chapter09186a00803deb1a.html

With Figure-3 and 4.

2) If you required too much secure with scalability of user and sites. You can follow RADIUS and TACACS+ Technology also.

Regards,

Dharmesh Purohit