cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
719
Views
0
Helpful
1
Replies

VPN Client - Failing to conect to ASA 5505

danielstaunton
Level 1
Level 1

Hi,

I get these following messages in my syslog,when I try to connect to my asa using the cisco vpn client.

IP = remoteip, Received encrypted packet with no matching SA, dropping

Group = RASVPN, Username = administrator, IP = remoteip, Session disconnected. Session Type: IPSec, Duration: 0h:00m:00s, Bytes xmt: 0, Bytes rcv: 0, Reason: crypto map policy not found

Group = RASVPN, Username = administrator, IP = remoteip, Removing peer from correlator table failed, no match!

Group = RASVPN, Username = administrator, IP = remoteip,QM FSM error (P2 struct &0x3c9f388, mess id 0x2a0ab40b)!Group = RASVPN, Username = administrator, IP = remoteip, Rejecting IPSec tunnel: no matching crypto map entry for remote proxy 192.168.100.1/255.255.255.255/0/0 local proxy 0.0.0.0/0.0.0.0/0/0 on interface outside

Group = RASVPN, Username = administrator, IP = remoteIP, PHASE 1 COMPLETED

Group = RASVPN, Username = administrator, IP = remoteip, Assigned private IP address 192.168.100.1 to remote user

Group = RASVPN, Username = administrator, IP = remoteip, Client Type: WinNT Client Application Version: 5.0.01.0600

Group = RASVPN, Username = administrator, IP = remoteip, Received unknown transaction mode attribute: 28684

Group = RASVPN, Username = administrator, IP = remoteip, Received unsupported transaction mode attribute:

It has been working for a while, but it stopped when I added a new site to site tunnel.

can anyone please help?

1 Reply 1

ANGUEL STEFANOV
Level 1
Level 1

make sure that the RA dynamic policy is mapped to your site-to-site static policy

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: