I'm stuck and really having a tough time figuring out the VPN configuration.
One of my friends was trying to help but he couldn't figure it out.
Details: He has the Cisco VPN Client and can connect to the ASA5505, I have the Windows Client (XP Home) and couldn't even connect (will try again tonight). When he connects, he said that he couldn't see any of our internal machines (Ping, etc). I have made a couple of changes today, and hope to try connecting again tonight.
The setup is just basic VPN, and the connecting machine should be able to access the entire internal office network.
I attached the latest configuration.
(Note: IP's have been changed and are bogus - to provide some mystery.)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...