I have never configured a site to site vpn tunnel with a Cisco router. I have done plenty with pix to pix but never a Cisco router. I am hoping for a little direction.
We have a site that just got Verizon Business grade Fios. I am a little confused on how I would set this up. It was suggested in another post that I would connect a cable from the Fa0/0 on thr 2811 to one of the switchports of the FIOS router...is this correct? What ip would I assisgn the Fa0/0? And then I assume the Fa0/1 would have an ip address of the internal lan?
Can someone post any sort of example of how the config would look on the 2811?
Thank you so much for any help or guidance you can provide.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...