Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

WAN

Hi,

we r going to configure and in headquarters we r using 2801 routers and in branch locations 1841 routers so we want to connect thorugh service provider can any one suggest me the complete plan how to connect as we have to establish connection between 8-sites to headquarters.

2 REPLIES

Re: WAN

Hi Phani

You can refer the link where you have similar scenarios discussed.

do check out the Hub n Spoke concept discussed over there and also if you are planning to use NAT then use the NAT config with route map accordingly..

http://www.cisco.com/en/US/tech/tk583/tk372/tech_configuration_examples_list.html#anchor18

regds

New Member

Re: WAN

Greetings Mate,

If you want the simplest of solutions, configuring GRE between the Main branch and remote branches and configuring default route to pass all the traffic to main site.

The above scenario considers that your branches connect to Internet through your Main branch.

If your branches connect to Internet themselves, you might have to do the necessary changes in routes and perform NAT at branches.

For configuration examples, you can refer to the above post by sprem

* Please rate if helpful

128
Views
1
Helpful
2
Replies
CreatePlease to create content