what i need to make As5400 as remote access server

[jawwalit]

dear sir:

i need to buy an AS5400 as to allow remote access users (using analog line) to access local network i have only one PRI line, My points what modules i need as to add to AS500 so to make a full system.

thanks

[Georg Pauwen]

Hello,

basically, one PRI would be enough to get you started. The AS5400 supports, AFAIK, 8 PRIs. Find below a link to a sample config of an AS5400 with one PRI configured for async dialup:

Configuring an AS5350/AS5400 for Incoming Async and ISDN Calls

http://www.cisco.com/en/US/products/hw/univgate/ps505/products_configuration_example09186a0080094a49.shtml

HTH,

GP

[jawwalit]

thanks,

can i use the following product number :

1) AS5400

with

2) as535-DFC-4CE1

with

3) as54-DFC-108NP

as to make dial up system

thanks

[Georg Pauwen]

Hello,

yes, this is a valid configuration, just keep in mind that you also need the AS54-DFC-CC= (AS5400 DFC CARRIER CARD) to hold the AS54-DFC-108NP.

Here is the hardware config for your selection:

Hardware Configuration

Chassis A5400AC-TS (CHASSIS, DUAL AC, IP+ IOS, 256MB SDRAM, Y-AC CABLE)

DIAL FEATURE CARD (DFC) SLOT 1 OPTIONS AS535-DFC-4CE1= (AS5350 Quad E1/PRI DFC card)

CARRIER CARD WITH OPTIONS FOR DFC SLOTS 2 AND 3 AS54-DFC-CC= (AS5400 DFC CARRIER CARD)

DIAL FEATURE CARD (DFC) SLOT 2 OPTIONS AS54-DFC-108NP= (AS5400 108 Universal Port Card)

DIAL FEATURE CARD (DFC) SLOT 3 OPTIONS Empty

HTH,

GP