when Serial Goes Down and ISDN Picks Up configure required
The best advice I can give you is to talk to your local cisco rep and have them help you to configure that.
why ? We are missing alot of information that we need to know to do a good job and this is not just a lab or test, this I understand, is a live network and if we make this wrong it will not funktion as intended.
It is better to talk to a local ciscorep and they can go over the full design with you so that you do not get a nasty surprise when things do not go they way they are supposed to.
Also you will make contact with someone that can come and help you on short notice and knows your environment.
To have information here on the forums is all good and well but it is not a substitute for a real techguy being there with you to help you when things go wrong or to help you plan the network and contingency plans.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...