Discover a problem implementing dialin access with wic-2am on cisco 2811. Plugged in 2 wic-2am= card to slot 0/1 and slot 0/3 on the router. But during test only port 0/1/0 and 0/3/1 can be utilized. The other 2 ports, 0/1/1 and 0/3/0 wont accept or make any call. Dont see any issues with compatibility when I run through software advisor and have tried downgrade and upgrade IOS several time. Have another remote router, same model and IOS version with NM-8AM which is working find. What's the problem? Need your expert advice. Thanks.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...