Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WIC-2AM using multiple AT commands and Dial String

I am using a WIC-2AM v2 card in a 2811 router.  We currently have one defined AT command string (we have the second port shut down).  I need to enable the second port, assign a new AT Command string disabling the v.90 and most likely slowing the speed down to 14400 (I need to be able to use the second WIC-2AM port to dial out over INMARST).  Is this even possible?  If so, how would I accomplish this, it has been quite a while since I have had to mess with AT commands.

Thanks

Everyone's tags (4)
965
Views
0
Helpful
0
Replies