Routers - Small Business

Regards,I have problems with the RV042 router. Currently I have two Internet service is the first DSL service and the other is through cable. The problem is because the router is not doing the redundancy process. For example if DSL service fails, the...

We have an ASA as a central hub in an IPSec VPN community, with four RVS4000 branch office routers connecting into it.Setting up the VPN tunnels worked fine, except after a while the tunnels seem to disconnect all by themselves, and they will not rec...

Hi there,I'm trying to setup a VPN tunnel between a Cisco RVS4000 on our side and a Cisco ASA5520, to connect a machine on our local network to a test server on the target side. We have all the settings setup correctly and the tunnel is up and runnin...

The VPN tunnel to one of my my branch offices sometimes shows status "connected" (on both sides) even if the tunnel is down (ping fails).It seems to happen directly after a WAN reconnect which occurs every 24h (forced by ISP). The problems starts occ...

Hi.I'm using 470  (and counting) RV042 v1 and v3 and RV042G for VPN gateway to gateway to HQ for more than 2 years. I have following issues with few units at a time, but repeat random on several:- VPN tunnel work several days, and then remain disconn...

   Hello All, I am trying to establish a site to site VPN with a RV180 connecting back to a corporate Network using an ASA 5510.  I have the RV180 setup with the Remote IP setting and a FQDN all setup and  I am able to tracert back to the ASA but I w...

           I'm use this router as a main router as my WISP connections. ISP assigned static. RV042 is in Gateway Mode.  Can someone explain to me the different's between gateway mode and router mode.

Hiwe recently buoght an Huawuei E173 usb 3G stick from the italian TRE mobile company.The stick is working fine when connected to a PC but it is not detected when connected to our SRP.We have the latest firmware 1.2.5 (001) Nov 8 2012 and the updated...

I am working with a RV180w and need to map drives from the internal network to the VPN client but whenever I try to connect to a shared drive I continue to get authentication messages from the DC.  I am pulling what little hair I have left out!!!  do...

Hello everyone.I am running across an issue where the site-to-site VPN. Below is a quick rundown of the basic info along with some log file snippits.Here is a rundown of the setup.Site 1.    Static IP.     192.168.1.x/24 LAN DHCP       Connects to Si...