Routers - Small Business

Hi,I have 2 RV082 routers in 2 separate cities.  Each is connected to broadband at each location with decent speed.  One has address range 192.168.1.x and the other has address range 192.168.2.x.  I was able to establish a gateway-to-gateway VPN conn...

Hello everybody,Here is the scenario of my network:- A company with 20 branches in Rio de Janeiro area. The main servers are in a datacenter located in downtown.Each branch has a RV042 router with firmware version 1.3.12.19-tm (Feb 13 2009 13:03:21) ...

Hi all,Im having problems with setting up my cisco WAP4410N as a repeater to extend the signal of cisco E2500.It works fine when there is no password to be set on both devices. But when either one of these devices had beenset a password on it, then W...

Hello,We are using router RV042 since last three it's working fine with single broadband connection but when we are using as a load balance it will hanged three or four time in a single day. I have updated firmware also but still my problem is not re...

Hi,I see a lots of problem associated with wirless connectivity with WRVS4400N, with following configFirmware version - Firmware Version: V1.1.13 Wireless connectivity - G/N MixedAuth - WPA2 AESEverything else default and AUTO,Problem:The end devices...

Hello, I have a Cisco WRVS4400N V2. I need to find a replacement AC adapter and the stands if possble. Can anyone direct me to the right place? Thanks.

Client:12 users, 3 servers, 5 smartphones/tables on the WiFi (existing AP), future VPN server (maybe 5 simultaneous inbound VPN connections at the most with at least one client using a Mac), Cisco Gigabit small business switchNeeds:Internet access, V...

Hello,I recently started using this service and I have a couple of issues with it:1) Even the IP's that are in the 'approved clients' list can't connect to blocked sites such as mail.yahoo.com, facebook.com2) I have a couple of websites in the 'appro...

I've got a RVS4000 (V1).  It's worked great for years and had many features that I didn't need (ACLs, VLANs and GbE, Jumbo Frames)...until this year.Unfortunately, I've discovered an issue with the connection tracking for built-in VLAN 1 that breaks ...

I have set up an RV042 v1 and v3 both in Load Balancing mode.  Set in Router mode.I want one of the WAN ports to be preferred so I added a static route to 0.0.0.0 metric 5 to that WAN.Sometimes the route shows in the routing table and sometimes it go...

I recently purchased a RV110W wireless router for a client.  I am having issues with the VPN access.  Here is the client's access log:2012/04/17 10:59:41 [STATUS]Disconnecting...2012/04/17 10:59:47 [STATUS]Success to disconnect.2012/04/17 11:00:03 [S...

I have a WRVS4400N, which for the most part performs fine except for this.  I have a PPTP VPN connection setup on my home computer and laptop to our office.  Its the simple MS VPN to an ISA server back in the office.When i try to connect via the VPN ...

Hi, I've buy a SRP500 Series Router (ADSL 2+).My ISP need RFC1483 Routed with LCC encapsulation type but this router dont have this type of encapsulation available in WAN settings. What can i do to use this device with my ISP adsl connection ?