Routers - Small Business

Hello,my RV042 crashed after i tried to enable SSHd, using it's build-in telnet CLI.I used the commands shown in the openRG users manual.Everything went fine (the device responded like "expected", answering my commands with a number an AFAIR OK) unti...

Is it possible to forward complete traffic to, say, 77.88.99.100:1080 to 192.168.1.50:80 in my local network. I can forward port 1080 to 192.168.1.50, but it forwards to port 1080, and I would like to forward to port 80The ruter is Linksys RV042.

I have a weird problem that maybe someone can help me out with.  This is the scenario.I have a three location setup.Location A:RV042Static T1192.168.10.x network schemeLocation B:RV082PPPoE DSL10.0.1.x network schemeLocation C:RV082Dynamic Cable Mode...

i've 2 adsl lines (1Mbps download speed and 512Kbps upload speed) and used rv042 for load balancing.but sometimes, IM program like gtalks don't work well.sign out and sign in again and againi adjusted MTU sizes (1500, 1490, 1492, 1480) and still have...

Hi All,The Protectlink URL page on the SA520 will show you how many times a filter instance has been blocked. I would also like to be able to see which client IP address was responsible. Their is a Protectlink page in the loggs section, but even thou...

Hi.I've just purchased a Linksys WRP400 Wireless-G Broadband Router with 2 phone ports (to replace a Billion voip wireless router which has ceased to function). I'm having trouble trying to work out how to set up the voip connection to my voip provid...

Hi, I'm new to the community, so hello!  I'm haveing a problem with my rvs 4000.  I am using verizon fios for my internet connection and have their Actionteck m1424wr router/modem.  Not even getting into help with VPN, i'm trying to just get the basi...

In my case i should use the wrv200 as a router with static routes.A tried to set up a route 0.0.0.0 0.0.0.0 192.168.1.254.I did not get any error messages after clicking the "save changes" button, but it does not work and it can't be seen on the rout...

Does anyone know if there is an update to the WRVS4400N IPS I am tired getting warning that it is old.  Did they move where it is?  All I see it the ver2.0 firmware.  Any help would be apprecitate.David

Hi,I am having an issue with the rv042 routers doing a gateway to gateway ipsec tunnel. The tunnel's say they are up but stop passing traffic, they might stay up for days or weeks (but not months), each time they require a manual reset of the tunnel ...

OK here's what I'm trying to do.Two separate VLANS networks through my RVS4000, namely 192.168.2.xxx ports 1-2 and 192.168.77.xxx port 3.The RVS4000 gets the internet via a static PPOE modem. The RVS4000, supplies the internet username and password f...

HelloI am trying to provision IP Phones and I need to set Option 66 on my WRV210 router. The router is running firmware      2.0.0.11 if that helps. Please let me know if this is possible.ThanksRoss

All:We have a rather intricate network setup at our office. We now have two ISPs AT&T using a Netopia (this was our original ISP) and a Comcast business connection. We have purchased the Cisco/Linksys R042 to use both WAN connections to boost our spe...

DISABLE REMOTE MANAGEMENT AND HTTPS.................