RV110W VPN tunnel configuration behind DSL modems

[kennethctaylor1961]

I have two sites which each have RV110W behind DSL modems. The RV110W's are looking for ID_INFORMATION relating to the DSL IP Address as that is the end of each tunnel, but they are sending their WAN IP address as ID so they don't match up. How do you configure around this? There must be an example of it somewhere but I cannot find it in any searching!

I had the tunnel up when I had replaced only one of my old routers - the old Zyxel router VPN premitted manually configuring the ID so I could get a tunnel up until I replaced the second router. As an aside however I couldn't pass traffic for some reason....

[Mike Williams]

I always put the DSL modems in transparent bridging mode and terminate PPPoE/PPPoA on the router/firewall to avoid problems like this. Last I checked, that particular router doesn't allow you to have an identity address different from the peer address. Regards, Mike