cancelar
Mostrando los resultados de 
Buscar en lugar de 
Quiere decir: 
Avisos
¡Bienvenido a la nueva Comunidad de Soporte de Cisco! Nos encantaría conocer su opinión
New Member

Configurar Aironet 1700 AIR-CAP1702I-A-K9

No puedo configurar...
Me pueden ayudar..
Mar  1 00:25:32.607: %CAPWAP-3-DHCP_RENEW: Could not discover WLC. Either IP ad
dress is not assigned or assigned IP is wrong. Renewing DHCP IP.
IOS Bootloader - Starting system.
flash is writable
Antigua Lite Board P2
40MB format
Tide XL MB - 40MB of flash
Xmodem file system is available.
flashfs[0]: 239 files, 8 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 41158656
flashfs[0]: Bytes used: 20173824
flashfs[0]: Bytes available: 20984832
flashfs[0]: flashfs fsck took 10 seconds.
Base Ethernet MAC address: 00:35:1a:78:af:98
Ethernet speed is 100 Mb - FULL Duplex
Loading "flash:/ap3g2-rcvk9w8-mx/ap3g2-rcvk9w8-mx"...#########################
File "flash:/ap3g2-rcvk9w8-mx/ap3g2-rcvk9w8-mx" uncompressed and installed, entr
y point: 0x2003000
executing...
Secondary Bootloader - Starting system.
Antigua Lite Board P2
40MB format
Tide XL MB - 40MB of flash
Xmodem file system is available.
flashfs[0]: 239 files, 8 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 41158656
flashfs[0]: Bytes used: 20173824
flashfs[0]: Bytes available: 20984832
flashfs[0]: flashfs fsck took 11 seconds.
flashfs[1]: 0 files, 1 directories
flashfs[1]: 0 orphaned files, 0 orphaned directories
flashfs[1]: Total bytes: 12257280
flashfs[1]: Bytes used: 1024
flashfs[1]: Bytes available: 12256256
flashfs[1]: flashfs fsck took 0 seconds.
Base Ethernet MAC address: 00:35:1a:78:af:98
Unable to locate IOS image with name **xx**.
Boot CMD: 'boot  flash:/ap3g2-rcvk9w8-mx/ap3g2-rcvk9w8-xx'
Loading "flash:/ap3g2-rcvk9w8-mx/ap3g2-rcvk9w8-xx"...###########################
#
File "flash:/ap3g2-rcvk9w8-mx/ap3g2-rcvk9w8-xx" uncompressed and installed, entr
y point: 0x1003000
executing...
              Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
           cisco Systems, Inc.
           170 West Tasman Drive
           San Jose, California 95134-1706
Cisco IOS Software, C1700 Software (AP3G2-RCVK9W8-M), Version 15.3(3)JC, RELEASE
 SOFTWARE (fc1)
Copyright (c) 1986-2015 by Cisco Systems, Inc.
Compiled Fri 11-Dec-15 11:55 by prod_rel_team
Antigua Lite Board P2
40MB format
Tide XL MB - 40MB of flash
Initializing flashfs...
flashfs[2]: 239 files, 8 directories
flashfs[2]: 0 orphaned files, 0 orphaned directories
flashfs[2]: Total bytes: 40900608
flashfs[2]: Bytes used: 20173824
flashfs[2]: Bytes available: 20726784
flashfs[2]: flashfs fsck took 11 seconds.
flashfs[2]: Initialization complete.
flashfs[3]: 0 files, 1 directories
flashfs[3]: 0 orphaned files, 0 orphaned directories
flashfs[3]: Total bytes: 11999232
flashfs[3]: Bytes used: 1024
flashfs[3]: Bytes available: 11998208
flashfs[3]: flashfs fsck took 1 seconds.
flashfs[3]: Initialization complete....done Initializing flashfs.
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
If you require further assistance please contact us by sending email to
cisco AIR-CAP1702I-A-K9 (PowerPC) processor (revision A0) with 376814K/134656K b
ytes of memory.
Processor board ID FCW2005N82Z
PowerPC CPU at 800Mhz, revision number 0x2151
Last reset from power-on
LWAPP image version 8.2.100.0
1 Gigabit Ethernet interface
32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: XX:XX:XX:XX:XX:XX
Part Number                          : XXXX
PCB Serial Number                    : XXXXX
Top Assembly Part Number             : XXXXXX
Top Assembly Serial Number           : XXXXXX
Top Revision Number                  : A0
Product/Model Number                 : AIR-CAP1702I-A-K9
% Please define a domain-name first.
ipv6 enable
  ^
% Invalid input detected at '^' marker.
ipv6 address autoconfig
  ^
% Invalid input detected at '^' marker.
ipv6 address dhcp
  ^
% Invalid input detected at '^' marker.
Press RETURN to get started!
*Mar  1 00:00:13.475: APAVC: Initial WLAN Buffers Given to System is  2500
*Mar  1 00:00:13.523: APAVC:  WlanPAKs 42878 RadioPaks  42270
*Mar  1 00:00:13.523: Starting Ethernet promiscuous mode
*Mar  1 00:00:13.527: %LWAPP-3-CLIENTERRORLOG: Load nvram:/lwapp_ap.cfg config f
ailed, trying backup...
*Mar  1 00:00:13.527: %LWAPP-3-CLIENTERRORLOG: Load nvram:/lwapp_ap.cfg.bak conf
ig failed...
*Mar  1 00:00:14.831: %LWAPP-4-CLIENTEVENTLOG: PnP waiting for capwap init
*Mar  1 00:00:15.503: %LINK-6-UPDOWN: Interface GigabitEthernet0, changed state
to up
*Mar  1 00:00:15.567: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C1700 Software (AP3G2-RCVK9W8-M), Version 15.3(3)JC, RELEASE
 SOFTWARE (fc1)
Copyright (c) 1986-2015 by Cisco Systems, Inc.
Compiled Fri 11-Dec-15 11:55 by prod_rel_team
*Mar  1 00:00:15.567: %SNMP-5-COLDSTART: SNMP agent on host ap is undergoing a c
old start
*Mar  1 00:00:15.607: %LINK-6-UPDOWN: Interface GigabitEthernet1, changed state
to up
*Mar  1 00:00:15.611: %CDP_PD-4-POWER_OK: Full power - HIGH_POWER inline power s
ource
*Mar  1 00:00:15.619: %LWAPP-3-CLIENTERRORLOG: Load nvram:/lwapp_ap.cfg config f
ailed, trying backup...
*Mar  1 00:00:15.619: %LWAPP-3-CLIENTERRORLOG: Load nvram:/lwapp_ap.cfg.bak conf
ig failed...
*Mar  1 00:00:15.619: spamInitRadCfg: recovery image default mode 0
lwapp_crypto_init: MIC Present and Parsed Successfully
*Mar  1 00:00:15.787: %SSH-5-ENABLED: SSH 2.0 has been enabled
*Mar  1 00:00:16.603: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, chan
ged state to up
*Mar  1 00:00:17.611: %LINK-5-CHANGED: Interface GigabitEthernet1, changed state
 to administratively down
*Mar  1 00:00:20.399: DPAA Initialization Complete
*Mar  1 00:00:20.399: %SYS-3-HARIKARI: Process DPAA INIT top-level routine exite
d
*Mar  1 00:00:27.607: %LINK-6-UPDOWN: Interface BVI1, changed state to down
*Mar  1 00:00:28.607: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, chan
ged state to down
bridge-group 1 source-learning
                ^
% Invalid input detected at '^' marker.
%Default route without gateway, if not a point-to-point interface, may impact pe
rformance
*Mar  1 00:00:34.531: %LWAPP-3-CLIENTERRORLOG: Load nvram:/lwapp_ap.cfg config f
ailed, trying backup...
*Mar  1 00:00:34.531: %LWAPP-3-CLIENTERRORLOG: Load nvram:/lwapp_ap.cfg.bak conf
ig failed...
*Mar  1 00:00:34.531: %CAPWAP-3-EVENTLOG: No Config Present. PNP required
*Mar  1 00:00:34.535: Cert ISSUER (39): cn=Cisco Manufacturing CA SHA2,o=Cisco
%Error opening flash:/capwap-saved-config (No such file or directory)
%Error opening flash:/capwap-saved-config-bak (No such file or directory)
Not in Bound state.
*Mar  1 00:01:22.563: %LWAPP-4-CLIENTEVENTLOG: Invoking capwap discovery
Etiquetas (1)
80
Visitas
0
ÚTIL
0
Respuestas