Ok Ill try and keep this as short as possible. Last week we had our MPLS service interrupted. Well once services were restored, all sites (we have 15 sites on MPLS) came back up except one. First thing I did was contact ATT. They were able to loo...
Ok Ill try and keep this as short as possible. Last week we had our MPLS service interrupted. Well once services were restored, all sites (we have 15 sites on MPLS) came back up except one. First thing I did was contact ATT. They were able to loo...
Hello. I have two 1941 routers with ipbasek9 license and each has, EHWIC4ESG, EHWIC-4SHDSL-EA, and two GigE ports. I'd like to configure ATM and keep it L2 and only have an IP on the router for management or SVI if needed. The intent is to connect...
Hi All, We are facing issue with arp.ARP is not getting updated on one of the internet router.ScenarioWe have 2 firewalls in cluster connected to 2 Internet routers. When doing FW fail over arp in not getting updated on primary internet router howeve...
Hi All, I am looking into the one of the 6800 Switch configuration and I found one command which i cannot understand, when we go to provisioning mode. Can any one explain what is virtual-slot and and how we found particular port-type number. modu...
Hello, good morning. i have problems to get access to the internet behind an 2911. Config should be as follows. internet is provided by an external dhcp server. signal comes through ge 0/1/0. The 2911 should be standard gateway and dhcp server fo...
I have live ip setup in Internet 1 & pppoe on 2nd so i want to forward my local pc's service to my static live ip For Egi have configure router as load balancer1)Having Static ip(live) - 10mb 2)Pppoe - 100mb connectionSo i have one local system runni...
Hi all, Which interfaces are supported and what licensing is required for MACSEC on the 4K ISR's? Thanks!
I'm deploying some 899G LTE routers that will need to support a small number (2) of Cisco IP phones. I'm not seeing availability for the typical LAN command "trust device cisco-phone" on any of the (8) GigabitEthernet PoE ports on the router. I'm co...
Hi dear friendsi have a question about a strange happeni have an ASR1006-X, this router has one port-channel interface (20Gbps) that about 1Gbps traffics comes from inside, in this router, i have 5 ACLs for matching traffic, and 5 nat pools for trans...
Hi,We have an ASR901 that is continuously generating the following log entries:unit 0 L2X analysisunit 0 L2X entry 25571 parity errorunit 0 IP2_INTR_STATUS parity processingunit 0 XQPORT_INTR_STATUS parity processingunit 0 MEM_FAIL_INT_STAT parity pr...
Hi all, I have the below software versions for 2811 routers and I am planning to upgrade them to the latest IOS version 15.1(4) (provided there is enough DRAM). Is it a good option to upgrade to latest version from 12.x version and also I heard tha...
Hi I am doing a LAB exercise and i need some answeres - i have my own public address that i would like to advertise out Scenario -1 If i have 1 router but pairing with 2 ISP's and want it to active/passive how do i achieve this? can i use local...
Hello, I have a Cisco ISR1921 router with IOS (c1900-universalk9-mz.SPA.151-4.M4). I inserted a WIC-2T (part number: 800-34377-01), and booted the router. I found that this WIC-2T is not supported. I would like to know now if there's any means to mak...
Hi All, Can someone help me to understand BGP's behavior here?I have 2 HQ's named Slough & Heathrow and multiple sites Eg. Bracknell here.I have BGP running between CE-PE. My concern here is that if I try to reach Slough subnets from Bracknell mentio...
Hi there, Thanks for reading. Is there an algorithm or methodology for right-sizing the circuit speed at the HQ Hub? I can't allow the remote sites to overflow the Hub but also don't want to throttle the spoke sites. It's a balance I'm searching fo...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-26-2024 09:18 AM | ||
04-26-2024 07:58 AM | ||
04-24-2024 03:30 PM | ||
04-24-2024 03:57 AM | ||
04-23-2024 05:38 PM |
User | Count |
---|---|
11 | |
9 | |
5 | |
2 | |
2 |