Routing

Hi Experts, I have the following design: LWAP--->cisco 3850 switches--->cisco 6800--->WLC5508. as in the attached diagram, I have 2 WLANs: Corporate users SSID Guest Users SSID. the network has Wireless laptops, mobile phones, Cisco wireless phone 79...

Hi Experts, I hope someone could help me on this topic. I have a scenario. Scenario#1: Access layer (cisco 3850 switch)--->Distribution Layer (Cisco 6800)--->Core Layer (Cisco ASR920). Scenario#1 topology is attached. on Access layer I am doing clas...

I have ISP home router with these settings on my job: DSL line status: VDSL2 Connections-Connection1: Access Type: VDSL, IP address: x.x.x.x, Default Gateway:y.y.y.y, DNS1: z.z.z.z, DNS2: w.w.w.w, Service list: INTERNET, Connection Type: IP_Routed ...

so i have one router and 2 switches and 2 pcs. the 2 pcs have ip address of 192.168.20.10 and the other one 192.168.10.10 from 20.10 i can ping 10.10 but i cant ping 20.10, i can only ping its gateway how can i solve this?

Dear Team;- Is this router supprorts the BVI configuration?    for example:Router(config)#bridge irb Router(config)#bridge 1 protocol ieee Router(config)#bridge 1 route ip Router(config)#interface bvi1 Router(config-if)#ip address x.x.x.x 255.255.255...

Hi All, I was doing a multicast lab to understand more about multicast routing. I have sparse-dense-mode running on all the interfaces. This is the routing table from one of the devices. Unlike the unicast routing table, this mroute table is bit more...

Hello all, I have a question and I am hoping you can answer it for me. I have a situation where I am going to have a isr 1941 connected to an ASA 5508. The public IP for the outside interface of the router and the ASA need to be on the same /29. T...

Hello EveryoneHello Cisco Pro People! I try here to install me 1841 Router for me 3 Client's here in house(Trust, Zone LAN), in the mean time i have read a lot of news paper, but now i dont see me next Step.  - If connect "ZONE Policy Security Intern...

Hi, I have 2 routers with 2 different QoS configs on the first router the class-map CENTURY-LINK_P4 is defined, but not used in the PRIORITIZE policy-map. on the second router the class-map CENTURY-LINK_P4 is defined and used in the PRIORITIZE poli...

Hi Experts, I have the attached topology, the 2 distribution switches are configured for VSS, and I need to configure VPC between N7Ks and distribution switches so all four links are bundled together. is it possible to do this? is it possible to run...